red security door for sale, brand-new and used.

This is used and in good condition. It has been tested and is working properly. It is 340mL and rated at 40 volts, 6 amps.

This is used in very good condition. It was made for an 8 liter culture vessel and is about 8 1/4 inches in diameter (adjustable) and three inches wide. It operates on 120 Volts AC.

This is used and is in good condition. It has some staining on the fabric mantle but not bad. It is for a 250mL round bottom flask.

This is used and is in good condition. It has some staining on the fabric mantle but not bad. It is for a 250mL round bottom flask.

This is used and in good condition. It is self contained and programmable from the keypad. This has been tested and is working properly and it looks good too.

Lightly used and in good condition. It heats properly and looks good too. 20 See the item photos above for the actual contents of the auction and the exact condition of the item elements.

This is a used temperature measuring transducer by Phoenix Contact. It is configured for a three wire PT100 RTD with a range of 0-100C with a 4-20 mA output. It has a very small footprint and is DIN rail mountable.

This is a used water bath temperature controller in good operating condition. It operates as it should. It has a connector for the EX-300 waterbath we have listed .

Welcome to Labb Surplus!!!

This is used and it has some kind of residue on the outside of it. I tried windex and alcohol and they didn't work. The inside is clean and it has been stored with a plastic cap on it.

This balance is in good condition and accurate when warmed up and level. It comes with the power supply but nothing else. 220 Grams x 0.1mg See the item photos above for the actual contents of the auction and the exact condition of the item elements.

This is a used calibration weight, the foam protector in the box is deteriorating and will need replacement. (pieces stick to the weight) The weight is in good condition. This is an E2 grade weight suitable for calibrating other calibration weights or balances as low as .01mg.

These are in good used condition. The current calibration is good, 20 gram calibration weight in the factory case. The case condition is a little rough but serviceable, these are class 4 weights.

This is used and has some yellowing and the stage is missing. It is otherwise in good condition. It has 45 degree 10 ocular lenses, camera adapter, manual focus column, 2x Achromatic objective lens and transmitted light base.

These cameras are unused with the PCI interface card and connecting cables, they are missing the proprietary power supply however. They are in the original box with the calibration certs. See the item photos above for the actual contents of the auction and the exact condition of the item elements.

I do not know who manufactured this but it is a quality job. The interior has a 3A polish. It mounts to a port with an ID of approximately four inches.

This is used and in good condition. The angle is adjustable even during operation. It can be timed or run continuous.

Thus is a used vortexer by VWR, it is in good overall condition although the feet are shot. It has a run and a timed run cycle, the time and motor speed are adjustable. The foam pads are less than perfect but servicable.

This tank is of heavy stainless steel. It has a lid with swing out doors and a center hole for a mixing impeller. It has four baffles inside that can be removed.

This is used and untested. E1A Card with cable. See the item photos above for the actual contents of the auction and the exact condition of the item elements.